How to install cutting discs? TRANRICH grinding technicians give the correct installation method. The seemingly simple operation requires careful handling. There are often incidents in which the operator is injured due to incorrect installation.
Step 1: Understand the basic knowledge
Familiar with the operation knowledge of the cutting machine, and the application of the scene. Cutting machine classification and cutting maximum power. In the process of use, pay attention to the speed of cutting and the use of time, regular maintenance and repair. The price of the cutting machine on the market is transparent, from high to low, and the suitable cutting machine should be selected according to the enterprise’s own situation.
Step 2: Check the cutting disc
Carefully check the cutting sheet and observe whether the surface of the cutting sheet is cracked and the cutting sheet is too soft. If one of these phenomena occurs, it is necessary to replace it in time to avoid dangerous accidents in the cutting process.
Step 3: Find the correct position
Find the position of the cutter shaft. The center bearing box protruding is the shaft locking device. Press the cylinder, turn the axis with the other hand, turn counterclockwise, the best way is to swing the axis from left to right. At the same time, when the cylinder meets the small hole on the shaft, the cylinder pins into the hole. The axis can’t rotate.
Step 4: Insert cutting disc
Hold the cylinder down and use the adjustable wrench with the other hand to loosen and remove the fastening bolt of the cutting piece. Remove the protective disc and paper pad in turn to prevent damage to the cutting sheet. Do not take out a protective disc inside, put the new cutting sheet into, and then install the paper pad and the protective disc in turn, and tighten.
Step 5: Run the cutting disc
At the beginning of the cutting can not be directly cut, to wait for the cutting machine idling for about 1-2 minutes. This is to ensure that there are no dangerous accidents when cutting.
The above is the correct installation steps of cutting pieces given by TRANRICH grinding technicians. From inspection to the beginning of testing, every step needs to be carefully treated. Ensure safe and correct operation.
Post time: Aug-02-2023
